Compuprint 4247-X03 - Manual (Page 136)

Rear Paper Load Position
This parameter adjusts the distance of the first printable line to the top of the
paper from −30 to +360 units (2 in.) (where each unit is 0.176 mm [1/144 in.]). The
default value is 0.
To change or check the Rear Paper Load Position:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Rear Form Load Position
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for Rear
Paper Load Position is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Bidirectional Adjustment
You can adjust dot registration and print quality for characters on your printer by
running the bidirectional adjustment test pattern. The test pattern consists of three
parts: two groups of H's (four lines each) with the current alignment value above
them and a line of H's and I's printed on one line. You can set bidirectional
adjustment from -6 to 6 (where each unit is 0.212 mm [1/120 in.]). The default
value is 0.
Note: Bidirectional Adjustment is available only in the Operator Print Tests menu.
To change or check the bidirectional adjustment:
1.
Press Test.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
OPERATOR PRINT TESTS
Printer Adjustments
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Bidirectional Adjustment
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Bidirectional Adjustment is displayed.
120 User’s Guide