Compuprint 4247-X03 - Manual (Page 67)

Recall Custom Set values
The Recall Custom Set values recalls configuration parameters previously stored.
(Custom sets are described in “Custom sets” on page 49.)
You can recall current values from:
v
Custom Set A
v Custom Set B
v Custom Set C
v Custom Set D
v Custom Set E
v Custom Set F
v Custom Set G
v Custom Set H
Note: When a new custom set is recalled, a partial reset is automatically
performed when exiting from the configuration menu if the value of at least
one of the parameters that requires a partial reset has been changed.
Buffered data will be lost.
To recall custom set values, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Configuration Storage
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Configuration Storage
Recall Custom Set Values
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired custom set
value is displayed.
7. Press ENTER. The printer displays a message similar to
Recall Custom Set
Custom Set A Recalled
8. Use START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Power-On Custom Set
The Power-On Custom Set is the custom set that is used when the printer is turned
on. The Last Used value means the custom set used before the printer was
powered off is to be used as the power-on custom set.
You can change the Power-On Custom Set to:
v
Last Used (Default)
v Custom Set A
v Custom Set B
v Custom Set C
Chapter 4. Configuration storage 51