Compuprint 4247-X03 - Manual (Page 54)

Checking and changing parameter values
Checking and changing Configuration Parameter Values is done in the
Configuration Menu, which is entered with the MENU key. The Configuration
Menu is divided into three levels:
v
Category
v Parameter
v Value
Note: Do not change Parameter Values during a print job; data may be lost.
Press MENU to enter the Configuration Menu.
CONFIGURATION MENU
Configuration Storage
The first category in the Configuration Menu is listed on the second line of the
display. Use SCROLL/MICRO or SCROLL/MICRO to scroll through the
Categories until the category you want is displayed. Press ENTER to display the
first Parameter in the Category you select. Use SCROLL/MICRO or
SCROLL/MICRO
to scroll through the Parameters until the parameter you want
to check or change is displayed. Press ENTER to display the current value for the
selected Parameter (indicated by an asterisk [*]).
Use SCROLL/MICRO and SCROLL/MICRO to scroll through the other
available Values until the value you want is displayed. Press ENTER to select this
new value.
When you change the values and do not save them in a custom set, the printer
retains the values until one of the following occurs:
v
You power off (O) the printer
v You change the values again
Unless you save the values in a custom set, the values you changed are lost when
you power off (O) the printer. The next time you power on (|) the printer, the
values you saved previously in the Power-On Custom Set, are the values the
printer uses.
See Chapter 4, “Configuration storage” for information about saving and recalling
parameter values in custom sets.
Configuration changes do not take effect until the printer completes printing the
buffered data (data the printer has in its storage areas).
If you change a parameter (or several parameters) and then decide you do not
want to keep your changes, you can return to the previous value settings by
selecting Quit from Menu from the Configuration Menu. The printer displays
Quit from Menu
Restore Previous Values
Press ENTER to restore the previous values, exit the Configuration Menu, and
make the printer not ready. See Chapter 15, “Quit From Menu” for more
information about restoring previous values.
38 User’s Guide