Compuprint 4247-X03 - Manual (Page 159)

To check or change printer adjustments:
1.
Press STOP to make the printer not ready.
2. Press TEST.
3. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
OPERATOR PRINT TESTS
Printer Adjustments
4. Press ENTER.
5. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Printer Adjustments is displayed.
6. Press ENTER and change the values you wish to change.
7. Press START to run a print test for acceptable quality and alignment.
If the quality is not acceptable, return to Step 4, otherwise, continue.
8. Press FORM FEED to see what you printed.
9. Press CANCEL PRINT to make the printer ready or RETURN to make the
printer not ready (see “General test instructions” on page 139).
Chapter 17. Using the Operator Print Tests 143