Compuprint 4247-X03 - Manual (Page 20)

3. Remove the remainder of the contents from the shipping container. (See
Appendix A, “Printer specifications” for dimensions of the table or printer
stand surface and the clearances required around the printer.)
4. If you have not already done so, remove the plastic bag from the printer.
5. Lift the bottom edge of the front tractor cover into the open position.
6. Remove the shipping locks from the printer.
Choosing a suitable location
CAUTION:
The 4247 printer weighs 21 kg (46 lbs). Two persons are required to lift
it.
Consider the following points when you choose the location for your printer:
v The distance between the printer and the host computer must not exceed the
length of the interface cable. The location must be sturdy, horizontal and stable
v Your printer must not be exposed to direct sunlight, extreme heat, cold, dust or
humidity (see Appendix A, “Printer specifications,” on page 165.
v You need a power outlet compatible with the plug of the printer's power cord.
v For best continuous forms stacking, the forms should be stacked on the floor or
on a surface below the base of the printer.
v For successful forms parking, the input forms stack must always be lower than
the base of the printer.
There must be sufficient
clearances on all sides for easy
operation. The required space is
shown in the following figure:
80 cm
31.5 in.
20 c m
7.9 i n
100
cm 39.4
in
20 cm
7.9 in
100
cm
39
.4
in
Hc0i0005
Figure 4. Printer clearances.
Figure 3. Removing the shipping locks from the printer.
4 User’s Guide