Bar code mode – Compuprint 4247-X03 User Manual
Page 80
CONFIGURATION MENU
IPDS Configuration
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
IPDS Configuration
Media Size Priority
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
media size priority is displayed.
7.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8.
Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Bar Code Mode
This parameter is valid only if the IPDS feature is installed and the IPDS data
stream is selected. Changing the value of this parameter can affect throughput in
some printing environments.
You can set the Bar Code Mode to any of the following values:
High
(Default)
High Contrast Bar Codes
Low
Low Contrast Bar Codes
Computer
Selected
Contrast as specified by the IPDS data stream
Note:
The printer performs a partial reset to put any change to this parameter
value into effect when you exit the Configuration Menu with START or
RETURN
. Buffered data will be lost.
To change or check the bar code mode, follow these steps:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
IPDS Configuration
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
IPDS Configuration
Bar Code Mode
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for bar
code mode is displayed
7.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
64
User’s Guide