Compuprint 4247-X03 - Manual (Page 93)

Disabled
(Default) No automatic carriage return is performed after a line feed.
Enabled An automatic carriage return is performed after a line feed.
Note: If Emulation Mode is set to Epson-FX, an automatic carriage return is
performed after a line feed regardless of the setting.
To change or check the automatic carriage return after a line feed setting, follow
these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Printer Compatibility
5. Press ENTER.
6. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Compatibility
4 (Auto CR on LF)
7. Press ENTER to display the current value.
8. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Automatic Carriage Return on Line Feed is displayed.
9. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Printer Compatibility 5 (form feed suppression)
This parameter is displayed when emulation mode is set to 4247, 4202 III XL, or
2381 Personal Printer.
You can set the printer to suppress host form feed commands or to honor all host
form feeds. You can set this value to:
Disabled
(Default) All form feed commands from the host are honored.
Enabled Form feed commands from the host are ignored if the printer is at top of
form and no data for the page was received.
Note: Operator panel form feeds are not affected.
To change or check form feed suppression, follow these steps:
1. Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Chapter 7. ASCII Configuration 77