Rear left margin alignment – Compuprint 4247-X03 User Manual
Page 135
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Rear Tear Position
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for Rear
Tear Position is displayed.
7.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8.
Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Rear Left Margin Alignment
This parameter adjusts the distance of the first print position to the left margin
from 0 to 60 units (where each unit is 0.706 mm [1/36 in.]). The default is 0 units.
The total range of adjustment is 42.36 mm (1.66 in.).
To change or check the Rear Left Margin Align:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Rear Left Margin Align
5.
Press ENTER to display the current value.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for Rear
Left Margin Align is displayed.
7.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8.
Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Note:
If the left margin alignment is too large for the current print line, an 005
MARGIN ERROR ADJ MARGIN/LINE LENGTH
will occur. For more information on
the message, see Chapter 19, “Problem solving,” on page 151.
Chapter 9. Printer adjustments
119