Compuprint 4247-X03 - Manual (Page 134)

Printer Adjustments
Front Form Load Position
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Front Paper Load Position is displayed.
7. Press ENTER.
An asterisk (*) is displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Rear Automatic Forms Thickness Adjustment (AFTA)
This parameter allows you to adjust the distance between the paper and the
printhead for the rear forms path. Forms must be loaded for this adjustment to be
effective. This adjustment can be set to one of the following values:
-5 to +3 The printer automatically adjusts the distance between the forms
and the printhead. Each adjustment corresponds to 0.03 mm (.0012
in.). (The default is 0, which corresponds to a gap of 0.25 mm [.01
in.] from the forms.)
Fixed 1 to 8 Selects a fixed printhead distance value from 1 to 8 in increments
of 0.5 (where each value equals approximately 0.05 mm [.002 in.]).
Default = 0
To change or check the Rear AFTA:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Rear AFTA
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for Rear
AFTA is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Rear Tear Position
You can adjust the rear tear position for forms loaded in the rear paper path from
-390 to +30 (where each unit is 0.176 mm [1/144 in.]). The default value is 0.
To change or check the Rear Tear Position:
1.
Press MENU.
118 User’s Guide