Compuprint 4247-X03 - Manual (Page 74)

Lines Per Inch (LPI)
You can set the lines per inch (LPI) for the printer to either of the following values:
v
6 (Default)
v 8
Note: This parameter can be overridden by the computer.
To change or check the LPI, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
IPDS Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
IPDS Configuration
Lines Per Inch
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for LPI
is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Maximum Print Position (MPP)
The maximum print position (MPP) equals the number of characters the printer
prints on a line. The default value is 132.
The CPI setting you choose directly influences the MPP value you select. The MPP
and CPI settings determine the length of the print line. The maximum line length
for the printer is 345.44 mm (13.6 in.).
The CPI setting and the line length determine the MPP. Multiply the CPI by the
line length to determine the appropriate MPP:
MPP = CPI x line length (in inches)
If your CPI is: MPP cannot be greater than:
10 136
12 163
15 204
16.7 227
Notes:
1. Setting the MPP larger than the paper width can result in lost data because of
printing on the platen and may damage the platen and the printhead.
2. This parameter can be overridden by the computer.
58 User’s Guide