Compuprint 4247-X03 - Manual (Page 81)

8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Graphics Mode
This parameter is available only if the IPDS feature is installed and the IPDS data
stream is selected. Changing the value of this parameter can affect throughput in
some printing environments.
You can set the Graphics Mode to any of the following values:
High
(Default) High Density Graphics
Low Low Density Graphics
Computer
Selected Density as specified by the IPDS data stream
Note: The printer performs a partial reset to put any change to this parameter
value into effect when you exit the Configuration Menu with START or
RETURN
. Buffered data will be lost.
To change or check the graphics mode, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
IPDS Configuration
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
IPDS Configuration
Graphics Mode
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
graphics mode is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the Configuration
Menu” on page 39.
Chapter 6. IPDS Configuration 65