Compuprint 4247-X03 - Manual (Page 51)

SET TOP OF FORM
This should only be used when printing occurred and no Top-of-Forms commands
have been passed to the printer (such as Form Feed or Printer initialization).
The Set Top of Form function is available only when the printer is not ready, and
the paper is loaded to the print line. This key can be used only for the continuous
forms paper sources.
Press SET TOP OF FORM to set the top of form position for continuous paper
sources only. The alarm beeps and the printer displays:
TOP OF FORM SET
while you hold down the SET TOP OF FORM key.
If preprinted forms are being used, use Paper Load Positioning (see Chapter 9,
“Printer adjustments,” on page 115) instead of Top-of-Form.
START
Press START to perform the following functions:
v Make the printer ready and cause the READY message to appear in the operator
panel display.
v Exit the Configuration Menu and make the printer ready. If a partial reset is
required, it is performed to put configuration changes into effect before the
printer becomes ready.
Note: If you have made configuration changes and have not saved them in a
Custom Set, the display will prompt you to save the changes.
v Start the printer printing if no error condition appears on the display and if the
computer is sending data to be printed.
v Begin a test from the Operator Print Tests menu.
STOP
If the printer is in a ready state, press STOP to:
v Make the printer not ready and cause the READY message to disappear from the
operator panel display
v Stop printing as soon as possible without losing print data
v Stop a test if the printer is in test mode
v Stop the printer alarm from beeping
v Allow you to use the other printer function keys
v Cause the printer to display:
Chapter 2. Understanding the operator panel 35