Comtech EF Data CRS-311 - Manual (Page 117)

CRS-311 1:1 Redundancy Switch Revision 7
Front Panel Operation MN/CRS311.IOM
5–7
5.2.2 CONFIG (Configuration)
CONFIG: MANUAL AUTO[OFF]
HOLDOFFS MASKS REMOTE
Use the ◄►arrow keys to move the cursor to the desired submenu, and then press ENTER.
The available submenus are:
Submenu Chapter Sect. Function
MANUAL 6.2.2.1
Use this submenu to select which Traffic Modem the Switch
should bridge or back up.
AUTO [ON / OFF] 6.2.2.2
Use this submenu to turn AUTO mode OFF or ON. The currently
selected state is always shown on this menu
HOLDOFFS 6.2.2.3
Use this submenu to set several operating parameters of the
Switch that pertain to enabling or disabling the availability of
Traffic Modems, the reporting of faults and time delays for
responding to faults.
MASKS 6.2.2.4
Use this submenu to set several operating parameters of the
Switch that pertain to enabling or disabling the availability of
Traffic Modems, the reporting of faults and time delays for
responding to faults.
REMOTE 6.2.2.5 Use this submenu to define the remote control settings.
The Switch may be monitored over the remote
control bus at any time. When in Local mode,
however, only configuration parameters may
be changed using the front panel.
Conversely, when in Remote mode, the unit
may be monitored from the front panel, but
configuration parameters may only be changed
via the remote control bus.