Comtech EF Data CRS-311 User Manual

Page 95

Advertising
background image

CRS-311 1:1 Redundancy Switch

Revision 7

Modem, RMI/TMI, and Switch Configuration MN/CRS311.IOM

4–5

4.2.4.2 Switch to SLM-5650/5650A Redundancy Configuration

4.2.4.2.1

TTL (Switch) Configuration (For All Traffic Data Types)

The CRS‐311 communicates to the Redundant and Traffic modems via a serial TTL bus contained 
within  the  HD‐15  “J9  Auxiliary”  connector  on  the  modem’s  rear  panel.  An  HD‐15M  to  HD‐15F 
Control Cable connects each modem to the CRS‐311. 
 
To  use  1:1  redundancy,  the  SLM‐5650/5650A  must  have  communications  configured  to  TTL 
(Switch) in order to communicate with the CRS‐311. 
 
Follow these steps to set the serial interface: 

Step

Task

1

From the SLM-5650/5650A front panel menu, navigate to Config: Remote Æ SerialConfig.

2

Set Interface to TTL (SWITCH).

3

Set Format to 8N1.

4

Set Baudrate to 9600 Baud.

5

Verify that Traffic Modem is ONLINE and the Redundant Modem is OFFLINE.

 
For  detailed  information  on  using  the  front  panel  menus,  see  Chapter  5.  FRONT  PANEL 
OPERATION 
in the SLM‐5650 or the SLM‐5650A Installation and Operation Manual

4.2.4.2.2

Ethernet Router Mode Configuration via Optional Network
Processor (NP) Interface

Ethernet  Router  Mode  redundancy,  when  using  SLM‐5650/5650A  modems  equipped  with  the 
optional  Network  Processor  (NP)  Interface,  is  provided  by  a  Dual  IP  Addresses  scheme.  In 
Ethernet  Router  Mode,  a  Single  IP  Address  should  NOT  be  used  and  will  be  automatically 
overwritten by the modem. You must verify that the modems are in Dual IP Address Mode. 
 
Follow these steps to verify the Dual IP Address Mode on the Online Modem: 

Step

Task

1

From the SLM-5650/5650A front panel, navigate to Config: Remote Æ EthernetConfig Æ
Option Card Addr
ÆNetwork Proc.

2

Verify that the Mode is set to DUAL.

A traffic IP Address is used as the gateway for networked devices. The traffic IP address always 
“floats”  with  whichever  modem  is  online.  The  traffic  IP  address  on  the  Offline  Modem  is 
inactivated.  
Follow these steps to enter the “shared” traffic IP address on the Online Modem: 

Advertising