Hypertherm HD3070 Plasma Arc Cutting System w/ Automatic Gas Console - Manual (Page 165)

5-40 HD3070 with Automatic Gas Console Instruction Manual
16
MAINTENANCE
PS ERR=6
TRANSFER TIMEOUT ERROR
(Continued)
Connect or replace
transfer current
sensor CS1.
Set correct
value for current.
No
Install new
consumables of
correct type.
No
Yes
Yes
Is current setting
correct ?
Yes
Are consumables of
correct type properly
installed & in good
condition ?
Replace control PCB
1XPCB3.
Fig 6-2 (4)
No
Yes
Is transfer current
sensor CS1
disconnected or
defective ?
Fig 6-9 (4)