Hypertherm HD3070 Plasma Arc Cutting System w/ Automatic Gas Console - Manual (Page 50)

3-2 HD3070 with Automatic Gas Console Instruction Manual
16
INSTALLATION
Pre-Installation
Prior to the installation of the HD3070 plasma cutting system, the components must be unpacked and the following
requirements must be fulfilled. Their purpose is to aid you in the installation of your plasma cutting system and to
allow maximum performance.
Installation and service of the electrical and plumbing systems must conform to national or local electrical
and plumbing codes. Have this work performed only by qualified, licensed personnel.
If questions arise at any time, call Technical Service listed in the front of this manual or your authorized Hypertherm
distributor.
Upon Receipt
Before unpacking the HD3070 System, inspect the box(es) for evidence of damage during shipment. If there is
evidence of damage, refer to Claims for Damage During Shipment below for details. Remove all packing material
and discard and remove the units and items from the box(es). Verify that the components listed below are included.
Alert Hypertherm if any of the items are damaged or missing. All communications regarding this equipment must
include the model number and serial number (located on the back of the units). Refer to Claims below for details.
HD3070 System Components
• Power Supply (078072, 078073, 078074, 078075 or 078076)
• Automatic Gas Console (078061)
• Remote High Frequency Console (RHF) (078010)
• PAC184 Torch Assembly (028839 or 128199)
PAC186 Torch Assembly (128101 or 128102)
• 45° Torch Quick Disconnect Assembly (028840) or
Straight Torch Quick Disconnect Assembly (028855)
• Off-Valve Assembly (129239 or 129281)
• PAC184 Consumable Parts Kit (028842 or 028900)
• PAC186 Consumable Parts Kit (128097 or 128098)
• Power Supply Service Parts Kit (028724)
• System Interconnecting Cables & Hoses
• HD3070 with Automatic Gas Console Instruction Manual (802180)
Optional Units
• Timer-Counter ( 078049)
• Remote Current Control (RCC) (078050)
Claims
Claims Claims for damage during shipment – If your unit was damaged during shipment, you must file a claim
with the carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional
assistance, call Customer Service listed in the front of this manual or your authorized Hypertherm distributor.
Claims for defective or missing merchandise – If any of the merchandise is defective or missing, call your
authorized Hypertherm distributor. If you need additional assistance, call Customer Service listed in the front of this
manual or your authorized Hypertherm distributor.