Hypertherm HD3070 Plasma Arc Cutting System w/ Automatic Gas Console - Manual (Page 203)

6-2 HD3070 with Automatic Gas Console Instruction Manual
16
PARTS LIST
Introduction
In this section, a parts breakdown with supporting illustrations for the units which comprise the HD3070 system is
given. Part numbers for cables, hoses, and lead sets are also given.
Power Supplies
0 78072 – 200 VAC, 3 Phase, 50/60 Hz
0 78073 – 208 VAC, 3 Phase, 60 Hz
0 78074 – 220/380/415 VAC, 3 Phase, 50/60 Hz
0 78075 – 240/480 VAC, 3 Phase, 60 Hz
0 78076 – 600 VAC, 3 Phase, 60 Hz
Power Supply – Control Panel
Part
Item Number Description Designator Qty.
029947 HD3070 Enclosure SA 1
029988 HD3070 Enclosure SA (for 220/380/415V units) 1
1 001512 Panel, control 1
2 008786 Knob (used on item 11) 1
3 008787 Knob Lock, (used on item 11) 1
4 005088 Holder, lamp 1
5 005168 Bulb, 28VDC, .08 MA T3-1/4 1
6 005091 Cap, red 1
7 005122 Pushbutton, 2 NC, red, extended PB2 1
8 005121 Pushbutton, 2 NO, green, illmn. PB1/LT1 1
9 041545 PC BD Assy, interlock display 1XPCB5 1
029977 Thumbwheel SA, current 1
10 005182 Switch, 3-position BCD S1 1
029394 Potentiometer SA 1
11 009604 Res, variable, 100K
Ω
, 2W 10% 1 turn P1 1