Hypertherm HD3070 Plasma Arc Cutting System w/ Automatic Gas Console - Manual (Page 2)

Page of Change Description of Change Rev 17 to 18 7/25/02
iv, v, vi, vii, viii Updated Main Table of Contents to reflect changes below.
2.1 Updated TOC
2.10 & 11
Added page after 2-10 with torch art and dimensions for both the straight and 45 degree
recepticles. Moved text from 2-10 to 2-11
3.30 Added warning about vent hose.
4.1 Updated TOC
4.17-4.20 Put in updated version of "How to get better cut quality".
5.7 Was "continued on page 5-7". Changed to 5-9.
6.1 Updated TOC to match headers
Page of Change Description of Change Rev 16 to 17 4/15/02
Cover New Revision
Title Page New Revision
2.3 Added figure reference to 2-3
2.8 Added Aluminum to 100A cutting
2.12
Moved figures for PAC184 & 186 from last page to the page with cooresponding
text. IEC symbols now on 2.12
5.28 Updated graphic to resemble new board
5.66 Updated graphic to resemble new board
5.72 Revised chopper figure to new configuration
6.4
Changed item # 5 (041580) to 041752 & 081032 to 081077. Updated graphic to
resemble new board
6.6 Revised chopper figure to new configuration
6.14 Cng P/N from 029618 to 129618
wiring diagram
Fixed diagrams that had missing lines. Section is now after section 6 instead of at
the very end of manual.