Yaesu FTM-10R - Manual (Page 31)

29 FTM-10R O
PERATING
M
ANUAL
P
UBLIC
A
DDRESS FEATURE
The Public Address feature enables the output of your voice to the transceiver’s speaker.
When an optional MLS-200-M10 External Speaker is connected, the FTM-10R allows
the transceiver to be used as an 8 W Public Address system.
1. Press the top panel / key to select “PA”.
2. Press the key to activate the Public Address feature.
3. Press the PTT key, and speak into the microphone in a nor-
mal voice level.
U You may select the PTT key function via Menu Item “F24 PTT MODE”.
MOMENT : While pressing the PTT key, the audio is output from the speaker (fac-
tory default).
TOGGLE : Once the PTT key is pressed the audio is output from the speaker, and
when the PTT key is pressed once again, the audio output is off.
U Your voice is output to the speaker.
U The “P A” notation appears in the display while the Public Address is activated.
U Press the [VOL/SEL] key to adjust the volume (AF level) of the PA output. While
the RED LED is on, the volume level can be adjusted with the dial knob.
CAUTION!
When the function is changed to the radio mode, the volume level remains the same.
Please be careful about the volume level setting.
U You may adjust the audio output level by rotating the DIAL knob while
To disable the Public Address feature, repeat steps 1 and 2 above.
Note: Please be careful that the PA function does not cause any
inconvenience or disturbance for others in your area.
R
EVERSE FEATURE
The Reverse feature reverses transmit and receive frequencies while working through a
repeater.
It is often helpful to be able to check the uplink (input) frequency of a repeater, to see if the
calling station is within direct (“Simplex”) range.
1. Press the top panel / key to select “REVERSE”.
2. Press the key to activate the Reverse feature.
The “ ” or “ ” or “ ” icon will blink while “Reverse”
shift is activated.
3. Press the key again to revert to the “Normal” shift direction.
S
MART
M
ENU
F
EATURES
Graphic Bar