Yaesu FTM-10R - Manual (Page 38)

36 FTM-10R O
PERATING
M
ANUAL
M
EMORY
G
ROUP
B
ANK
In the FTM-10R, the memory channel is assigned to the Group Memory Bank automati-
cally. The Group Memory Bank can be recalled by pressing the front panel
/ key (A
“GRP” notation appears at the upper left corner in the display for a moment.). You may
observe the Group Memory Bank between the Audio Line and 2 m Amateur Band.
You may assign/eliminate the memory channel to/from the Group Memory Bank. The elimi-
nated memory channel is only recalled by recalling the memory channel, which is stored in
the same operating band.
To eliminate the memory channel from the Group Memory bank:
1. Recall the memory channel you wish to delete from the Group Memory Bank.
2. Press and hold the
key for one second to enter the Memory Channel Customization
mode.
3. Rotate the DIAL knob to select Menu Item “M1 GROUP.”
Press the key briefly, then rotate the DIAL knob to se-
lect “OFF;” this deletes the current memory channel from
the Group Memory bank).
4. Press the [VOL/SEL] key to save the new setting and re-
turn to the memory recall mode.
To re-assign the eliminated memory channel into the Group Memory bank:
1. Press the front panel key to switch the VFO mode, if needed.
2. Press the front panel / keys to recall the operating band which is the same band
as the eliminated memory channel.
3. Press the front panel key again to switch the “Memory Recall” mode, and then
rotate the DIAL knob to select the memory channel you wish to re-assigned into the
Group Memory bank.
4. Press and hold the key for one second to enter the Memory Channel Customization
mode.
5. Rotate the DIAL knob to select Menu Item “M1 GROUP.”
6. Press the
key briefly, then rotate the DIAL knob to select “ON ON ON ON ON ;” The current memory
channel will be assigned into the Group Memory bank.
7. Press the [VOL/SEL] key to save the new setting and return to the memory recall mode.
M
EMORY
O
PERATION