Yaesu FTM-10R - Manual (Page 54)

52 FTM-10R O
PERATING
M
ANUAL
C
HANGING THE
C
LUB
C
HANNEL FREQUENCY
By factory default, the 439.900 MHz (EXP Version:433.500 MHz) frequency is stored in
the Club Channel. If you wish to change the Club Channel, perform the following steps.
ADVICE: For the “Club Channel”, any frequency in the 144 MHz or 440 MHz amateur
bands can be programmed. However, the Message Clone function and the Clone
function can work only on the 440 MHz band. When these functions are used,
select the 440 MHz band.
1. Press the front panel / key to recall the Group
Memory Bank (“GRP” notation appears at the upper left
corner in the display for a moment).
When the display indicates the Clock, Stop Watch Timer,
or Temperature, press the [VOL/SEL] key to change the VFO or memory mode, then
perform the above selection.
2. Rotate the DIAL knob to select the Club Channel (The “CLB”
notation appears at the upper left corner in the display for
two seconds, then changes to the “GRP” notation).
3. Press and hold the key for one second to enter the Club
Channel Customization mode.
4. Rotate the DIAL knob to select Menu Item “C1 CLUB FRQ.”
5. Press the
key momentarily, to display the current memo-
rized frequency of the Club Channel and the “SET” nota-
tion will be blinking.
6. Press and hold the key for one second to enable the changing of the Club Channel
frequency.
The blinking “SET” notation changes to the blinking “CLB” notation.
7. Rotate the DIAL knob to select the desired Club Channel frequency.
You may change the operating band (430 MHz to 144 MHz, or vice versa) by pressing
the front panel
/ keys.
8. Press and hold the key for one second to save the new Club Channel frequency.
The blinking “CLB” notation returns to the blinking “SET” notation.
9. Press the [VOL/SEL] key to save the new setting and exit to normal operation.
M
ESSAGE
F
EATURE