Yaesu FTM-10R - Manual (Page 95)

93 FTM-10R O
PERATING
M
ANUAL
M
ENU
(“S
ET
”) M
ODE
Set Mode Item [F3 AF PITCH F3 AF PITCH F3 AF PITCH F3 AF PITCH F3 AF PITCH]
Function: Select the Tone Pitch control for the received audio.
Available Values: LOW-3/LOW-2/LOW-1/NORMAL/HIGH-1/HIGH-2
Default: NORMAL
Set Mode Item [F4 AF PREST F4 AF PREST F4 AF PREST F4 AF PREST F4 AF PREST]
Function: Enable/Disable the Volume Setting Alert feature.
Available Values: OFF/OV ALERT/LV ALERT/ HV ALERT
Default: OFF
OV ALERT
: Activates the Volume Setting Alert feature. A lamp at the left of the DIAL knob
blinks orange when volume level is set to the ±3 steps of the preset level.
LV ALERT : Activates the Volume Setting Alert feature. A lamp at the left of the DIAL knob
blinks orange when volume level is set to the preset level minus 3 steps.
HV ALERT : Activates the Volume Setting Alert feature. A lamp at the left of the DIAL knob
blinks orange when volume level is set to the preset level plus 3 steps above.
OFF : Disables the Volume Setting Alert feature.
Set Mode Item [F5 AF-VFO F5 AF-VFO F5 AF-VFO F5 AF-VFO F5 AF-VFO]
Function: Select the DIAL knob and display function.
Available Values: TOGGLE/AUTOBACK
Default: AUTOBACK
TOGGLE
: Keeps the DIAL knob function and display until the [VOL/SEL] key is pressed
once again.
AUTOBACK : The DIAL knob function and display comes back to frequency selection and
frequency display after approximately 3 secs.
Set Mode Item [F6 BEEP F6 BEEP F6 BEEP F6 BEEP F6 BEEP]
Function: Enables/Disables the beeper.
Available Values: KEY+SC/KEY/OFF
Default: KEY+SC
KEY+SC
: The beeper sounds when you press any key, or when the scanner stops.
KEY : The beeper sounds when you press any key.
OFF : Beeper is disabled.
Set Mode Item [F7 BLU SAVE F7 BLU SAVE F7 BLU SAVE F7 BLU SAVE F7 BLU SAVE]
Function: Enable/Disable the battery saver of the optional BH-1 Bluetooth Headset.
Available Values: OFF/ON
Default: OFF