Visara 5350 - Manual (Page 102)

Nov 06
5-8 35PPM Laser Printer User Guide
Fuser Unit
Fuser Unit
This section explains about the fuser unit.
Caution on Handling the Fuser Unit
The fuser unit is included as one of the regular replacement parts. Before replacing the fuser unit,
open the box of the regular replacement parts and get the new fuser unit ready.
When handling the fuser unit, take note of the following points:
Do not replace the fuser unit immediately after using the printer. You may get burned.
Replacing the Fuser Unit
1. Switch off the power of the printer and leave it for 30 minutes until the fuser unit cools
down.
CAUTION: Never touch a labeled area found on or near the heat roller. You can get burnt. If a
sheet of paper is wrapped around the heat roller, do not try to remove it by yourself to avoid inju-
ries or burns. Switch off the machine immediately, and contact our Printer Support Desk.
Be sure to switch off and unplug the machine before accessing the interior of the machine for
cleaning, maintenance, or fault clearance. Access to a live machine’s interior can cause electric
shock.