System menu, System menu 7-19 – Visara 5350 User Manual
Page 161
Nov 06
35PPM Laser Printer User Guide
7-19
System Menu
System Menu
The system menu provides access to system settings. Use the following procedure to enter the sys-
tem menu:
1.
Press the MENU button on the control panel.
2.
Press the NEXT button until the text System Menu is shown on the second line of the dis-
play.
3.
Press the SELECT button to enter the system menu.
4.
Press the NEXT button to move through the submenus: Factory Defaults, Display Lan-
guage, Power Saver, Wait Timeout, Job Timeout, Jam Recovery, Hex Print, Toner
Low, Page Compression, and Intellifilter.
5.
Press the SELECT button to enter a submenu.
Use the procedures in the following table to access and change the system settings:
Submenus
Default Setting
Available
Settings
Procedure for Changing Setting
Factory Defaults
This submenu allows you to reset
the printer to U.S. or Non-U.S.
factory defaults.
U.S.
U.S.
Non-U.S.
1. Press NEXT or PREVIOUS to toggle
between U.S. and NON-U.S.
2. Press SELECT to choose and set the
factory defaults.
Display Language
This submenu allows you to
change the language of the
display messages.
English
English
Francais (French)
Deutsch (German)
Italiano (Italian)
Espanol (Spanish)
1. Press NEXT or PREVIOUS to scroll
through the available languages:
English, French (Francais), German
(Deutsch), Italian (Italiano), or
Spanish (Espanol).
2. Press SELECT to choose and set the
language.
Power Saver
15
1 – 60
1. Press NEXT or PREVIOUS to
increase or decrease the digit.
2. Press SELECT to save this setting.
Wait Timeout
This submenu allows you to
increase or decrease the length
of time (in seconds) that the
printer will remain in the waiting
state—a job is being processed,
no end-of-file has been detected,
and there is no more data to
process. This setting applies to
both PCL and PostScript print
jobs.
00020
0 – 99999
1. Press NEXT or PREVIOUS to
increase or decrease each digit of the
five-digit number.
2. Press SELECT set one digit and move
to the next digit.
3. Press SELECT after changing the last
digit to save this setting.
Job Timeout
This submenu allows you to
increase or decrease the time
limit (in seconds) for PostScript
jobs. A 0 setting indicates no
timeout. This setting applies only
to PostScript jobs.
00000
0 – 99999
1. Press NEXT or PREVIOUS to
increase or decrease each digit of the
five-digit number.
2. Press SELECT set one digit and move
to the next digit.
3. Press SELECT after changing the last
digit to save this setting.