Westermo GD-01 - Manual (Page 145)

145 6196-2220
+WRST – Reset
Description:
This command allows to reset the module after the time specified by the second param-
eter.
Syntax:
AT+WRST =<Mode>,<Delay>
Response Syntax:
+WRST: <Mode>,<Delay>,<RemainTime>
Command example Possible responses Note
AT+WRST=? OK
AT+WRST=0 OK Disable timer
AT+WRST=1,”001:03” OK Enable timer and put
delay at 1 hour 3 minutes
AT+WRST? +WRST: 1,”001:03”, Timer activated to reset
”001:01” after 1 hour and 3 minutes.
OK Actually 1 hour and 1
minute remaining before
next reset.
Defined values:
<val1>
0: timer reset is disabled
1: timer reset is enabled
<Delay>
“000:00”- “168:59”: specify the time for reset
<RemainTime>
“000:00”- “168:59”: time before next reset
B A C K