Westermo GD-01 - Manual (Page 175)

175 6196-2220
AT+WGIPCPINF – Get IPCP informations, (GPRS command)
Description
This command get the current IPCP informations to use with a particular cid after a PDP
activation.
These parameters are not saved in persistent memory and are only available during the
life of the PDP context.
If the cid is not defined then ERROR is returned.
Syntax
AT+WGIPCPINF=[<cid> [,<cid [,...]]]
AT+WGIPCPINF=?
Response Syntax:
+WGIPCPINF: <cid>,<@DNS1>,<@DNS2>,<@gateway>
[<CR><LF> +WGIPCPINF: <cid>,<@DNS1>,<@DNS2>,<@gateway>[...]]
OK
ERROR
Response on ” AT+WGIPCPINF=?”:
+WGIPCPINF: (list of supported <cid>s)
OK
Defined Values:
<cid>
(PDP Context Identifier) a numeric parameter (1-32) which specifies a particular PDP
context definition.The parameter is local to the TE-MT interface and is used in other
PDP context-related commands.
<@DNS1> and <@DNS2>:
String parameters which are IPV4 DNS address.
<@gateway>:
String parameter which is IPV4 address
NOTE: These parameters are optional and depend of the operator setup.
Command example Possible responses
AT+WGIPCPINF +WGIPCPINF:1,62.201.129.99,62.201.159.99,13.9..130
+WGIPCPINF:2
+WGIPCPINF:3
OK
B A C K