Westermo GD-01 - Manual (Page 88)

88 6196-2220
+CLCC – List current calls
Description:
This command is used to return a list of current calls.
Syntax:
AT+CLCC
Response syntax:
OK if no calls are available
+CLCC: <id1>, <dir>, <stat>, <mode>, <mpty> [ ,<number>, <type>
[<alpha> ] ][ <CR><LF>
+CLCC: <id2>, <dir>, <stat>, <mode>, <mpty> [ ,<number>, <type>
[<alpha> ] ] [. . . ] ] ]
Defined values:
<idx>
Integer type, call identification as described in GSM 02.30
<dir>
0: mobile originated (MO) call
1: mobile terminated (MT) call
<stat> (state of the call):
0: active
1: held
2: dialling (MO call)
3: alerting (MO call)
4: incoming (MT call)
5: waiting (MT call)
<mode>(teleservice):
0: voice
1: data
2: fax
9: unknown
<mpty>
0: call is not one of multiparty (conference) call parties
1: call is one of multiparty (conference) call parties
<number>: string type phone number in format specified by <type>
<type>: type of address octet in integer format
<alpha>: optional string type alphanumeric representation of <number>
corresponding to the entry found in phonebook.
(for UCS2 format see commands examples +CLIP, +CCWA or +COLP)
B A C K