Westermo GD-01 - Manual (Page 155)

155 6196-2220
Response on “+CGQMIN=?”:
+CGQMIN: <PDP_type>, (list of supported <precedence>s),
(list of supported <delay>s), (list of supported <reliability>s),
(list of supported <peak>s), (list of supported <mean>s) [<CR><LF>+CGQMIN:
<PDP_type>, (list of supported <precedence>s), (list of supported <delay>s),
(list of supported <reliability>s) , (list of supported <peak>s),
(list of supported <mean>s) [...]]
Defined values:
<cid>:
A numeric parameter which specifies a particular PDP context .
<precedence>:
A numeric parameter which specifies the precedence class.
<delay>:
A numeric parameter which specifies the delay class.
<reliability>:
A numeric parameter which specifies the reliability class.
<peak>:
A numeric parameter which specifies the peak throughput class.
<mean>:
A numeric parameter which specifies the mean throughput class.
If a value is omitted for a particular class then this class is not checked.
Command example Possible responses
AT +CGQMIN=1,1,4,5,2,31 OK
AT+CGQMIN=? +CGQMIN: “IP”, (1-3), (1-4), (1-5), (1-9), (1-31)
+CGQMIN: “PPP”, (1-3), (1-4), (1-5), (1-9), (1-31)
OK
AT+CGQMIN? +CGQMIN: 1,1,4,5,2,14
OK
B A C K