Westermo GD-01 - Manual (Page 150)

150 6196-2220
Command example Possible responses Note
AT +CGDCONT=1, OK Set context 1
"IP", "internet"
AT +GCDCONT=2, "IP", OK Set context 2
"abc.com"
AT+CGDCONT=? +CGDCONT=(1-32), Possible values
“IP”,,,(0-1),(0-1)
+CGDCONT=(1-32),
”PPP”,,,0,0
OK
AT+CGDCONT? +CGDCONT=1, "IP", Request current contexts
"internet",,0,0
+CGDCONT=2, "IP",
"abc.com",,0,0
OK
+CGQREQ – Quality of Service Profile (Requested),
(GPRS command)
Description
This command allows the TE to specify a Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.The set command
specifies a profile for the context identified by the local context identification parameter,
<cid>. Since this is the same parameter that is used in the +CGDCONT command, the
+CGQREQ command is effectively an extension to the +CGDCONT command.
The QoS profile consists of a number of parameters, each of which may be set to a
separate value. A special form of the set command, +CGQREQ= <cid> causes the
requested profile for context number <cid> to become undefined.The read command
returns the current settings for each defined context.The test command returns values
supported as a compound value. If the MT supports several PDP types, the parameter
value ranges for each PDP type are returned on a separate line.
Syntax:
+CGQREQ=[<cid> [,<precedence > [,<delay> [,<reliability.> [,<peak> [,<mean>]]]]]]
+CGQREQ?
+CGQREQ=?
Response Syntax:
OK
ERROR
Response on “+CGQREQ?”:
+CGQREQ: <cid>, <precedence >, <delay>, <reliability>, <peak>, <mean>
[<CR><LF>+CGQREQ: <cid>, <precedence >, <delay>, <reliability.>, <peak>, <mean>
[...]]
B A C K