Westermo GD-01 - Manual (Page 172)

172 6196-2220
Defined Values:
<PDP Context Time>
Duration between the activation and deactivation of the PDP context in secondes
<Data IN>:
data volume received by the MS in Kb
<Data OUT>:
data volume sent by the MS in Kb
+WGPRS – GPRS PARAMETERS CUSTOM, (GPRS command)
Description
This command modify some GPRS parameters as the ATTACH-STATUS (the ME
don’t make automatically a GPRS attachment after init: yes/no), the PDP-INIT-STATUS
(activate automatically some define PDP Contexts after init: yes/no) and the use (yes/no)
of NAT (IP address translation on PPP).
In addition this command permit to set “ACTIVABLE” automatically after init some
define PDP contexts.
NOTE: The unit must be reboot to activate the new setup.
Syntax
AT+WGPRS=<mode>,<parameter>,[<cid>]
AT+WGPRS=?
AT+WGPRS?
Response Syntax:
OK
ERROR
Response on ”AT+WGPRS=?”:
+WGPRS: <mode>, <parameter1>,[<cid>]
[<CR><LF>+WGPRS: <mode>,
<parameter>,[<cid>]
[...]]
Response on “ AT+WGPRS?”
+WGPRS:<mode>(list of supported <parameter>),[(list of supported <cid>)]
[<CR><LF>+WGPRS:<mode>(list of supported <parameter>),
[(list of supported <cid>)] [...]]
B A C K