Westermo GD-01 - Manual (Page 188)

188 6196-2220
Fax Class 2 indication messages
The following messages are used to indicate DCE Responses.
The messages below are used in communication only.
+FCON:
This response indicates connection with a fax machine.
+FDCS <vr>,<br>,<wd>,<ln>,<df>,<ec>,<bf>,<st>:
This response reports current session capabilities.The parameters are the same than
those of AT+FDIS command
+FDIS <vr>,<br>,<wd>,<ln>,<df>,<ec>,<bf>,<st>:
This response reports remote capabilities.The parameters are the same than those of
AT+FDIS command.
+FCFR:
This response indicates confirmation to receive.
+FTSI “<string>”:
This response reports the received transmit station ID string.
+FCSI “<string>”:
This response reports the received called station ID string.
+FPTS <ppr>:
This response reports received page transfer status.The parameter is the same than the
one of AT+FPTS command (see 13.4).
+FET <ppm>:
This response reports post page message response.The parameter is the same than the
one of AT+FET command (see 13.3).
+FHNG <cause>:
This response reports the hang-up cause. It indicates that the call has been terminated.
<cause>
0: Normal end of connection.
10: Unspecified transmit phase A error.
20: Unspecified transmit phase B error.
40: Unspecified transmit phase C error.
50: Unspecified transmit phase D error.
70: Unspecified receive phase B error.
90: Unspecified receive phase C error.
100: Unspecified receive phase D error.
B A C K