Yaskawa Sigma-5 Series User Manual:: For Use with Large-Capacity Models-Setup. Rotary Motors - Manual (Page 35)

2.4 EMC Installation Conditions
2-13
Installation
2.4
EMC Installation Conditions
This section describes the recommended installation conditions that satisfy EMC
guidelines for each model of the SERVOPACK and converter.
The EMC installation conditions that are described in this section were used when
Yaskawa products passed the EMC conformance testing. The actual EMC level will
depend on the actual device configuration, wiring, and other conditions. However,
because this product is built-in, check that the conditions are still met after being
installed in the user’s product.
2.4.1 SGDV-††††01A (Analog Pulse Model)
„ Three-phase 200 V
• SERVOPACK: SGDV-†††H01A (††† = 121, 161, 201)
• Converter: SGDV-COA††AA (†† = 2B, 3G)
Note: 1T: 1 turn
2T: 2 turns
For details, refer to 2.4.5 Other Precautions.
*3
L1, L2, L3
B1, B2
CN101
CN103, 104
200 VAC
CN901
P N
P N
1T
2T
1T
1T
1T
1T
ࠦࠕ 1T
U, V, W
CN2
CN901
CN103, 104
DU, DV, DW
CN115
CN8
2T
CN1
*2
*4
*1
Power supply:
Three-phase
200 VAC
Clamp Core
Surge
absorber
Noise
filter
Shield box
Clamp
Converter
Regenerative
resistor
Core
Fan
Servomotor
Encoder
Clamp
Clamp
Core
Core
Core
SERVOPACK
Core
Clamp
Clamp
Clamp
Dynamic
brake unit
Host
controller
Safety
device
Surge
absorber
Noise
filter Core
次回用