GE Industrial Solutions Entellisys System User Manual - Manual (Page 122)

Sequence of events, fault reports, and waveform capture records 122
9
9.5 Viewing waveforms
To view a waveform capture on the HMI screen, highlight the event in the SOE listing with which
the waveform is associated and click the Waveform button.
The waveforms in Figure 9-3 were captured from an overcurrent condition. At the left of each
time line, magnitude data or operation status are shown for the displayed waveform trace.
Figure 9-3 Waveforms captured from an overcurrent condition
At the top of the window, the Trigger Date (D/M/Y) and time of triggering (to nearest
microsecond) are displayed.
The Cursor 1, Cursor 2 numeric values indicate the position of the corresponding cursor from
the start of the record. The Delta numeric value displays the time difference between Cursor 1
and Cursor 2.