GE Industrial Solutions Entellisys System User Manual - Manual (Page 187)

Sequence of events cause code cross reference index 187
A
A Alarms and events
A.1 Sequence of events cause code cross reference index
The following table lists the sequence of events cause codes. To view a description of these
events and a troubleshooting guide, see
Alarms and events description and system
troubleshooting guide on page 208 .
Table A-1 Sequence of events cause code cross reference index
Cause Event Text Page
H-0001 HMI Startup page 208
H-0002 HMI Shutdown page 208
H-0003 HMI Resumed Communication with [CPUA/B] page 209
H-0004 HMI Lost Communication with [CPUA/B] page 209
H-0005 HMI couldn't Establish Communication with [CPUA/B] page 209
H-0006 Default CPU set to CPUA page 212
H-0007 Default CPU set to CPUB page 212
H-0008 Messnger Commission Command Sent for Breaker [Name] page 212
H-0009 Messnger Decommission Command Sent for Breaker [Name] page 212‘
H-000A IP Address for CPUA Set To [n.n.n.n] From [n.n.n.n] page 209
H-000B IP Address for CPUB Set To [n.n.n.n] From [n.n.n.n] page 209
H-000C Frequency Set To [50/60]Hz for [CPUA/B] page 212
H-000D Caution: Settings Failed Writing Frequency to [CPUA/B] page 212
H-000E Caution: Settings Failed Writing Commission Status To [CPUA/B] page 213
H-0012 Time Synchronization Disabled page 212
H-0013 Time Synchronization Enabled page 212
H-0014 Time Synchronization Frequency Set To [NN] Hours page 212
H-0015 Time Synchronization Successful page 212
H-0016 Caution: Time Synchronization Failed with [CPU A/B] page 212
H-0018 Caution: Firmware Download Failed for [CPU A/B/Messngr].Unable to Enable Flash
Pgm Mode. Replace CPU page 210