GE Industrial Solutions CPS6000 - Manual (Page 40)

CPS6000 –48V Indoor/Outdoor Power Shelf
Issue 21 January 2008
40
Installing the CPS6000 Shelf
CPS6000 Unpacking and Installation
There are two distribution options for the CPS6000, a Single-Slot Distribution Module and a
Bulk Output Module. Only one distribution box can be used in a CPS6000 shelf. This
hardware assembly is field installable, however in most cases the factory will have already
installed the distribution module when it is required.
Step Action
1. Unpacking. Inspect the shipping container for any signs of damage. If damage
exists, have the carrier’s representative sign a note acknowledging the damage.
2. Carefully cut the sealing tape and remove the shelf from the carton. Use the
parts list to verify all materials are included. Save the shipping package until all
parts are operating within specifications.
3. Is there a Distribution Module already installed in the right-most shelf
position?
Yes - Go to the Install the
CPS6000 shelf section. No – Continue
4. Remove the Distribution Module Assembly from the carton. The Assembly and
the shelf will be shipped in separate cartons.
5. Is the Single-Slot or the Bulk Output Distribution Module being installed?
Bulk Output Distribution
Module - Go to Step 8. Single-Slot or Double-Slot Distribution
Module - Continue.
6. Slide the Assembly into the rightmost slot.
7. Verify the hook on the front engages under the shelf. See Figure 5-1.
Figure 5-1: Distribution Module