Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 104)

90 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring switch virtual interfaces
4
Select the Add button (within the Secondary IP Addresses field) to define additional addresses
from a sub screen. Choose an existing secondary address and select Edit or Delete to revise or
remove a secondary address.
9. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
10. Click OK to use the changes to the running configuration and close the dialog.
11. Click Cancel to close the dialog without committing updates to the running configuration.
Modifying a virtual interface
To modify an existing virtual interface.
NOTE
When changing from a default DHCP address to a fixed IP address, set a static route first. This is
critical when the switch is being accessed from a subnet not directly connected to the switch and
the default route was set from DHCP.
1. Select Network > Switch Virtual Interface from the main tree menu.
2. Select the Configuration tab and click the Edit button.
The screen displays with the name of the VLAN in the upper left-hand side. The VLAN ID cannot
be modified and should be used to associate the VLAN ID with the description and IP address
assignments defined.