Configuring e-mail notifications – Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) User Manual
Page 463
Brocade Mobility RFS7000-GR Controller System Reference Guide
449
53-1001944-01
Configuring SNMP Traps
7
Those sub-items previously enabled (with a check to the left) now display with an "X" to the left
of them.
10. Click Apply to save the trap configurations enabled using the Enable or Enable all sub-items
options.
11. Click Revert to discard any updates and revert back to its last saved configuration.
Configuring E-mail notifications
To enable e-mail notification:
1. Select Management Access > SNMP Trap Configuration from the main menu tree.
2. Click the Email Configuration button to launch a dialogue where you can configure outgoing
E-mail servers and and addresses for alerts.
3. Check the Enable SMTP box to enable the outgoing mail server on the switch. In order to use
E-mail notification on the switch, this box must be checked.
Configure the SMTP mail server properties as follows:
Name
Enter the hostname of your outgoing SMTP mail server. This is the server that is
used to deliver outgoing mail.
Port
Specify the port number used by your outgoing SMTP server. In many cases this is
port 25.