Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 357)

Brocade Mobility RFS7000-GR Controller System Reference Guide 343
53-1001944-01
Configuring firewalls and access control lists
6
4. Click the Add button within the Associated Rules field.
5. Use the Precedence field to enter a precedence (priority) value between 1 and 5000.
The rules within an ACL will be applied to packets based on their precedence value. Rules with
lower precedence are always applied first.
NOTE
If adding an access control entry to an ACL using the switch SNMP interface, Precedence is a
required parameter.
6. Use the Operation drop-down menu to define a permit, deny or mark designation for the ACL. If
the action is to mark, the packet is tagged for priority.
7. Select the Logging checkbox to generate log messages when a packet has been forwarded,
denied or marked based on the criteria specified in the access lists.
8. If mark is selected from within the Operations drop-down menu, the Attribute to mark field is
enabled. Select the 802.1p (0 - 7) or TOS(0 - 255) or DSCP(0-63) checkbox and define the
attribute receiving priority with this ACL mark designation.
9. From within the Filters field, select a Source Mask Length from the drop-down menu.
The Source Mask Length is the size of the network or host (in mask format). The mask length
defines a match based on the Network / Host.
10. Use the Source Address field to enter the IP address where the packets are sourced.
11. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
12. Click OK to use the changes to the running configuration and close the dialog.
13. Click Cancel to close the dialog without committing updates to the running configuration.