Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 226)

212 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring access ports
4
1. Select Network > Access Port from the main menu tree.
2. Click the Adopted AP tab.
3. Refer to the Adopted AP screen for the following information:
Switch The Switch field displays the IP address of the cluster member associated with
each AP. When clustering is enabled on the switch and Cluster GUI is enabled the
Switch field will be available on the AP configuration screen. For information on
configuring enabling Cluster GUI, see
“Managing clustering using the Web UI” on
page 280.
MAC Address Displays the radio's first MAC address when it is adopted by the switch.
Model Displays the model number of the Access Port.
AP Type Displays the Access Port type.
Serial Displays the serial number of the Access Port, and is used for switch management
purposes. It is read-only and cannot be modified.
HW Version Displays the hardware version of the Access Port. This information can be helpful
when troubleshooting problems with the Access Port.
IP Address Displays the IP address of the adopted Access Port.
Bootloader Displays the software version the Access Port boots from. This information can be
helpful when troubleshooting problems.
Protocol Version Displays the version of the interface protocol between the Access Port and the
switch. This information can be helpful when troubleshooting problems with the
Access Port.
Fw Version Displays the Access Port firmware version at run time. Use this information to
assess whether the software requires an upgrade for better compatibility with the
switch.