Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 228)

214 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring access ports
4
1. Select Network > Access Port from the main menu tree.
2. Click the Unadopted AP tab.
The Unadopted AP tab displays the following information:
3. Select an available index and click the Adopt button to display a screen wherein the properties
of a new radio can be added for adoption to the switch. When displayed, the screen prompts
for the MAC address and type of radio. Complete the fields and click the OK button to add the
radio.
4. Click the Export button to export the contents of the table to a Comma Separated Values file
(CSV).
CAUTION
An Access Port is required to have a DHCP provided IP address before attempting layer 3
adoption, otherwise it will not work. Additionally, the Access Port must be able to find the IP
addresses of the switches on the network. To locate switch IP addresses on the network:
Index Displays a numerical identifier used to associate a particular Access Port with a set
of statistics and can help differentiate the Access Port from other Access Ports
with similar attributes.
MAC Address Displays the unique Hardware or Media Access Control (MAC) address for the
Access Port. Access ports with dual radios will have a unique MAC address for
each radio. The MAC address is hard coded at the factory and cannot be modified.
Last Seen (In Seconds) Displays the time the Access Port was last seen (observed within the switch
managed network). This value is expressed in seconds. Use this value to assess if
the Access Port is no longer in communications with the switch.
Number of Unadopted
APs Displays the total number of Access Ports (at the bottom of the screen) that have
been recognized, but not adopted by the switch.