Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 325)

Brocade Mobility RFS7000-GR Controller System Reference Guide 311
53-1001944-01
AP intrusion detection
6
8. Select an Allowed AP and click the Edit button to launch a screen used to modify the index and
SSID of the AP. For more information, see “Adding or editing an allowed AP” on page 311.
9. Select an Allowed AP and click the Delete button to remove the AP from list of Allowed APs.
10. Click the Add button to display a screen used to enter device information for a new AP added
to the Allowed AP list. For more information, see “Adding or editing an allowed AP” on
page 311.
Adding or editing an allowed AP
To add a new address range or modify the address range used to designate devices as allowed:
1. Select Security > Access Point Intrusion Detection from the main tree menu.
2. Click the Configuration tab.
3. Select an existing Allowed AP and click the Edit button to modify the properties of an existing
Allowed AP or click the Add button to define the attributes of a new Allowed AP.
4. If adding a new Allowed AP, use the Index parameter to assign a numerical index value to this
particular Access Point. The index range is from 1-200. If editing an existing Allowed AP, this is
a read only field and cannot be modified.
ESSID Displays the ESSIDs of the Allowed AP(s). The addresses displayed are defined by
clicking the Add button and entering a specific MAC address or by allowing all MAC
addresses to be allowed. The list of MAC addresses allowed can be modified by
highlighting an existing entry, clicking the Edit button and revising the properties of
the MAC address.
Type Displays the Access Port or Adaptive AP model or each allowed AP.