Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 177)

Brocade Mobility RFS7000-GR Controller System Reference Guide 163
53-1001944-01
Viewing Access Port Information
4
1. Select Network > Access Port Radios from the main menu tree.
2. Click the Configuration tab.
3. Refer to the table for the following information:
Switch The Switch field displays the IP address of the cluster member associated with
each Access Port radio. When clustering is enabled on the switch and Cluster GUI
is enabled the Switch field will be available on the Access Port radio configuration
screen. For information on configuring enabling Cluster GUI, see
“Managing
clustering using the Web UI” on page 280.
Index Displays the numerical index (device identifier) used with the device radio. Use this
index (along with the radio name) to differentiate the radio from other device
radios.
Description Displays a user assigned name for the radio.
AP Type Displays the type of Access Port detected. The switch supports Brocade Mobility
7131N-FGR Access Points.
Type Use the Type to identify whether the radio is 802.11a radio or an 802.11bg radio.
Adopted Displays the radio’s adoption status. If the radio is adopted, a green check
displays. If the radio is not adopted, a red X displays.
Parent AP MAC Address Displays the Access Port's Ethernet MAC (the device MAC address that is printed
on the casing of the unit). Please do not confuse this BSSID MAC with the Access
Port's Ethernet MAC address.
MAC Address The Base Radio MAC is the radio's first MAC address when it is adopted by the
Switch.
State Display the radio’s current operational mode. If the radio is set as a Detector AP,
the state is "Detector", otherwise the state is "Normal".
VLAN Displays the name of the VLAN currently used with each Access Port radio.