Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 468)

454 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring SNMP trap receivers
7
1. Select Management Access > SNMP Trap Receivers from the main menu tree.
2. Refer to the following SNMP trap receiver data to assess whether modifications are required.
3. Highlight an existing Trap Receiver and click the Edit button to display a sub-screen used to
modify the v2c or v3 Trap Receiver.
Edit Trap Receivers as needed if existing trap receiver information is insufficient. You can only
modify the IP address, port and v2c or v3 trap designation within the Edit screen. For more
information, see
“Editing SNMP trap receivers” on page 455.
4. Highlight an existing Trap Receiver and click the Delete button to remove the Trap Receiver
from the list of available destinations available to receive SNMP trap information.
Remove Trap Receivers as needed if the destination address information is no longer available
on the system.
5. Click the Add button to display a sub-screen used to assign a new Trap Receiver IP Address,
Port Number and v2c or v3 designation to the new trap.
Destination Address The Destination Address defines the numerical (non DNS name) destination IP
address for receiving traps sent by the SNMP agent.
Port The Port specifies a destination User Datagram Protocol (UDP) receiving traps.
Community String/User
Name Displays the Community String and User Name specific to the SNMP-capable client
that receives the traps. The community name is public.
Trap Version The Trap Version defines the trap version (v1/2 or v3) defined by the
SNMP-capable client receiving the trap. A trap designation cannot be modified.