Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 314)

300 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Locationing
5
5. The AP Information section displays the following information about APs:
6. Click the Edit button to alter the AP location.
7. Click the Delete button to remove the AP from the table.
8. Click the Add button to add a new AP location to the AP information table. For more
information, see “Adding AP Location information” on page 300.
9. Click the Apply button to save the changes made within this screen. Clicking Apply overwrites
the previous configuration.
10. Click the Revert button to disregard any changes made within this screen and revert back to
the last saved configuration.
Adding AP Location information
1. To add AP Location information for your site: Select Services > RTLS from the main menu tree.
2. Select the Site tab.
Height Enter the height of the site. The size is either in feet or meters depending on which
unit of measure is selected below. The acceptable range for height is 0-20m or
0-180ft. Height is an optional parameter and is not taken into account by the
locationing algorithm.
Unit Use the pulldown menu to select the unit of measure used for dimensions. The
options are feet or meters.
AP MAC Lists the MAC Addresses of all APs which have been configured for RTLS.
Location:
X Coordinate Displays the value of the X Coordinate for each AP. The X coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
configured and not detected by the switch. For information on how to configure AP
location information, see <Blue>Chapter , Adding AP Location information.
Location:
Y Coordinate Displays the value of the Y Coordinate for each AP. The Y coordinate is relative to
the origin point of 0,0 in the upper left corner of the site map. This value is user
configured and not detected by the switch. For information on how to configure AP
location information, see <Blue>Chapter , Adding AP Location information.
Location:
Z Coordinate Displays the value of the Z Coordinate for each AP. The Z coordinate is the height
of the AP relative to the lowest point of the site. This value is user configured and
not detected by the switch. For information on how to configure AP location
information, see <Blue>Chapter , Adding AP Location information.
Status Displays the status value for each AP.
Switch IP Displays the IP address of switch associated with each AP configured for RTLS.
11a Radio Displays the Index, MAC Address, Power and Channel information for the 802.11a
radio on each AP.
11b Radio Displays the Index, MAC Address, Power and Channel information for the 802.11bg
radio on each AP.