Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 478)

464 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Configuring management users
7
3. Select an existing RADIUS Server from those listed and click the Edit button at the bottom of
the screen.
4. Modify the following RADIUS Server attributes as necessary:
5. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
6. Click on OK to complete the modification of the RADIUS Server.
7. Click Cancel to revert back to the last saved configuration without saving any of your changes.
RADIUS Server Index Displays the read-only numerical Index value for the RADIUS Server to help
distinguish this server from other servers with a similar configuration (if
necessary). The maximum number that can be assigned is 32.
RADIUS Server IP
Address Modify the IP address of the external RADIUS server (if necessary). Ensure this
address is a valid IP address and not a DNS name.
RADIUS Server Port Change the TCP/IP port number for the RADIUS Server (if necessary). The port
range available for assignment is from 1 - 65535.
Number of retries to
communicate with
RADIUS Server Revise (if necessary) the maximum number of times the switch retransmits a
RADIUS Server frame before it times out of the authentication session. The
available range is between 0 - 100.
Time to wait for RADIUS
Server to reply Revise (if necessary) the maximum time (in seconds) the switch waits for the
RADIUS Server’s acknowledgment of authentication request packets before the
switch times out of the session. The configurable range is between 1 - 1000
seconds.
Encryption key shared
with RADIUS Server Enter the encryption key the switch and RADIUS Server share and must validate
before the user authentication scheme provided by the RADIUS Server can be
initiated.