Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 494)

480 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Debugging the applet
8
1. Select Diagnostics > Applet Debugging from the main menu.
2. To use this window, select the Enable Web-UI Debug Mode checkbox.
The Applet Debugging field is partitioned into the following editable fields:
• Send log message to a file.
• Use SNMP v2 only.
• Message Severity.
• What kinds of message should be seen.
3. Select the Send log message to a file checkbox if you wish to store the log message.
Enabling this checkbox allows you to select the file location where you wish to store the log
message.
4. Select the severity of the message you wish to store in the log file.
The Message Severity section allows you to report a bug and log it as per the following severity
levels:
• Fatal - loss of data or switch functionality
• Error - switch data compilation problem, could result in data loss
• Warning - potential data loss of configuration corruption
• Informational - data that may be useful in assessing a potential error
• Debug - information relevant to troubleshooting
• None - no impact.
5. Select the message deployed when a bug is raised.