Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 129)

Brocade Mobility RFS7000-GR Controller System Reference Guide 115
53-1001944-01
Viewing and configuring switch WLANs
4
4. Select the Hotspot button from within the Authentication field.
Ensure Advanced is selected from within the This WLAN’s Web Pages are of the drop-down
menu.
NOTE
Advanced hotspot configuration is not permissible using the switch Web UI. Refer to the switch CLI
or other advanced configuration options to define a hotspot with advanced properties. However, the
switch can still install and maintain directories containing Web page content.
5. Once the properties of the advanced hotspot have been defined, the file can be installed on
the switch and used to support the hotspot. The following parameters are required to upload
the file:
a. Specify a source hotspot configuration file. The file used at startup automatically displays
within the File parameter.
b. Refer to the Using drop-down menu to configure whether the hotspot file transfer is
conducted using FTP or TFTP.
c. Enter the IP Address of the server or system receiving the source hotspot configuration.
Ensure the IP address is valid or risk jeopardizing the success of the file transfer.
d. If using FTP, enter the User ID credentials required to transfer the configuration file from a
FTP server.
e. If using FTP, enter the Password required to send the configuration file from an FTP server.