Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 389)

Brocade Mobility RFS7000-GR Controller System Reference Guide 375
53-1001944-01
Configuring IKE settings
6
1. Select Security > IKE Settings from the main menu tree.
2. Click the Configurations tab.
During IKE negotiations, peers must identify themselves to one another. Thus, the
configuration you define is the identification medium for device recognition.
3. Set a Keep Alive interval (in seconds) the switch uses for monitoring the continued presence of
a peer and report of the client's continued presence. The client notifies you when the peer is
no longer present. The default interval is 10 seconds.
4. Click the Apply button (within the IKE Settings field) to save the configuration.
5. Click the Revert (within the IKE Settings field) to rollback to the previous configuration.
6. Refer to the Pre-shared Keys field to review the following information:
NOTE
Please note that RSA keys are not supported for IKE negotiation on this switch.
7. Highlight an existing set of pre-shared Keys and click the Edit button to revise the existing peer
IP address and key.
8. Select an existing entry and click the Delete button to remove it.
Peer IP Address Use the Peer IP Address to associate an IP address with the specific tunnel used by
a group of peers.
Key Displays the string ID a remote peer uses to look up pre-shared keys.