Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 411)

Brocade Mobility RFS7000-GR Controller System Reference Guide 397
53-1001944-01
Configuring IPSec VPN
6
1. Select Security > IPSec VPN from the main menu tree.
2. Click the Crypto Maps tab and select Manual SAs.
3. Refer to the read-only information displayed within the Manual SAs tab to determine whether a
Crypto Map (with a manually defined security association) requires modification or if a new one
requires creation.
4. If a Crypto Map with a manual security association requires revision, select it from amongst
those displayed and click the Edit button to revise its Seq #, IKE Peer, ACL ID and security
protocol.
5. Select an existing table entry and click the Delete button to remove it from the list of those
available to the switch.
Priority / Seq # Displays the Seq # (sequence number) used to determine priority. The lower the
number the higher the priority.
Name Displays the name assigned to the security association.
IKE Peer Displays the IKE peer used with the Crypto Map to build an IPSec security
association.
ACL ID Displays the ACL ID the Crypto Map’s data flow uses to establish access
permissions.
Transform Set Displays the transform set representing a combination of security protocols and
algorithms. During the security association negotiation, peers agree to use a
particular transform set for protecting the data flow.