Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 353)

Brocade Mobility RFS7000-GR Controller System Reference Guide 339
53-1001944-01
Configuring firewalls and access control lists
6
Define an Index (numerical identifier) for the ACL and the starting and ending MAC address
range for devices allowed/denied access to the switch managed network.
5. Enter an Index numerical value (1 -1000) in the MU-ACL Index field.
The MU-ACL Index is a numerical identifier used to associate a particular ACL to a range of
MAC addresses (or a single MAC address) either allowed or denied access to the switch
managed network. Enter a new Index to define a new MAC Address range and allow/deny ACL
Index designation.
6. Enter a hex value for the Starting MAC address.
This is the beginning MAC address either allowed or denied access to the switch managed
network.
7. Enter a hex value for the Ending MAC address. Enter the same Starting MAC address within the
Ending MAC field to use only the Starting MAC address as either allowed or denied access to
the switch managed network.
8. To modify the zone associated with the ACL select a Zone ID from the pulldown menu. Zone
numbers range from 1 to 48. Creating zones allows you to associate firewall policies to each
zone. All members of the same zone will have the same firewall policies applied to them.
9. Use the drop-down menu to select Allow or Deny.
This rule applies to MUs within the specified Starting and Ending MAC Address range. For
example, if the adoption rule is to Allow, access is granted for all MUs within the specified
range.
10. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
11. Click OK to use the changes to the running configuration and close the dialog.
12. Click Cancel to close the dialog without committing updates to the running configuration.